- - Coal Mining Slurry Pump
- - Slurry Pump
- - Rubber slurry pump
- - Gravel pump
- - High head slurry pump
- - Vertical slurry pump
- - Wear slurry pump
- - Foam pump/Froth Pump
- - Cover Plate Liner,Frame Plate Liner
- - Expeller Ring
- - Front Plate
- - Impeller
- - Volute Liner
- - Medium slurry pump
- - SP vertical slurry pump
- - Light slurry pump
- - Bearing Assembly
- - Rubber parts
slurry pump mechanical seal installation
Inspection and attention problems before slurry pump mechanical seal installed what? Installation of mechanical seals, cleanliness is essential. Before installation, in addition to the mechanical seal parts cleaned, it should also be sealed chamber end face and the hole wall, shaft and bushing surface cleaned, check for burrs, injury, and timely manner. Especially dynamic mechanical seals, high static sealing ring section apply cotton or grade of toilet paper carefully cleaned. Ensure no scratches or abrasions, and coated with a layer of clean engine oil on it to ensure a high degree of seal face clean before installing the fitting after, otherwise it will affect the slurry seal.
Department of precision mechanical parts mechanical seal parts, the assembly is prohibited forcibly beat. Particularly dynamic, static ring seal face higher accuracy, should be doubly protected allowed to bump scratch.