- - Coal Mining Slurry Pump
- - Slurry Pump
- - Rubber slurry pump
- - Gravel pump
- - High head slurry pump
- - Vertical slurry pump
- - Wear slurry pump
- - Foam pump/Froth Pump
- - Cover Plate Liner,Frame Plate Liner
- - Expeller Ring
- - Front Plate
- - Impeller
- - Volute Liner
- - Medium slurry pump
- - SP vertical slurry pump
- - Light slurry pump
- - Bearing Assembly
- - Rubber parts
Several industry standard slurry pump application requirements
1 packing water pressure should be higher than the pump outlet pressure of 35kPa.
2 Rolling bearings generally used, and the use of thin oil or grease lubrication, the working temperature should not exceed 75 ° C.
3 of the rubber inner shell bivalve pump, the maximum size of the slag solids in the slurry pump should not exceed 3mm, no sharp edges; pump housing for single, double metal shell within the pump casing, the solid particles in the slurry pump maximum size should not exceed 80% of the minimum size of the flow cross-section.
4 gear pump can be used flexible couplings, belts or fluid coupling and so on. Couplings, V belt and pulley should be security guards.
5 rubber lined impeller shall not exceed the maximum lift 63m. The maximum speed allowed by the line should not exceed 30m / m.
Several industry standard slurry pump application requirements