- - Coal Mining Slurry Pump
- - Slurry Pump
- - Rubber slurry pump
- - Gravel pump
- - High head slurry pump
- - Vertical slurry pump
- - Wear slurry pump
- - Foam pump/Froth Pump
- - Cover Plate Liner,Frame Plate Liner
- - Expeller Ring
- - Front Plate
- - Impeller
- - Volute Liner
- - Medium slurry pump
- - SP vertical slurry pump
- - Light slurry pump
- - Bearing Assembly
- - Rubber parts
slurry pump pipeline configuration import and export
slurry pump combination of factors to consider investing in diameter size (input costs), the system resistance, critical settling slurry pump flow rate, suction pipe should be as short and straight, in the suction inlet of the pump, preferably with the same period of the inlet diameter straight pipe, its length should not be less than three times the inlet diameter. Usually the flow rate of the suction tube is 1.7-2.5m / s.
slurry pump pump and motor should be installed on a solid foundation, not rubber, cushion pad to bear the full weight of slurry pump and eliminate vibration, anchor bolts should be tightened evenly. After pouring cement pump stand and bolt holes, cement to dry, then check the levelness.
Special attention is this: the weight of piping and valves should not be borne by the slurry pump, were considered the best of its support.
slurry pump pipeline configuration import and export